![]() ![]() You want hg update -C , which will clobber your current version with the requested version. I want to retrieve an old version of my project, what do I do? This will refuse to merge or overwrite local changes. If you're sure you want to update your working directory on a pull, you can also use hg pull -u. To update your working directory, run hg update. This keeps you from upsetting your work in progress, which may not be ready to merge with the new changes you've pulled and also allows you to manage merging more easily (see below about best practices). hg pull pulls all new changes from a remote repository into the local one but doesn't alter the working directory. There are two parts to Mercurial: the repository and the working directory. I did an hg pull and my working directory is empty! If you do not trust the network you are using do not change this. There's a reason for requiring SSL, however. If you are on a private network and you know that all HTTP clients are trustworthy, you can add That's because allowing anonymous, unauthenticated HTTP clients to push changes into your repository would be a huge security hole. I get an "ssl required" error message when trying to push changes Be careful to avoid paths managed by system package management, since package installations could conflict with it /usr/local/bin is usually a good choice. On the server, place a symlink to the hg binary somewhere on the ssh PATH run to show it. ![]() On the server, create a ~/.ssh/environment file that defines an appropriate PATH, and add PermitUserEnvironment yes to /etc/sshd_config. bashrc (or equivalent shell configuration file), noting that this may not always work for some versions of ssh and bash. As a one-off operation, you could write the clone command as follows: hg -config ui.remotecmd=/path/to/hg clone a PATH in.In your client ~/.hgrc file, set a remotecmd value in the section giving the exact path to hg. There are a few ways to deal with this problem: On the other hand, if the error message is remote: bash: line 1: hg: command not found, the problem is that the environment used by ssh does not have hg in its PATH. ![]() Remember to use and observe the remote command being executed via the ssh channel The path to the remote repository is relative to $HOME of USER. Mercurial's remote repository syntax differs from syntax of other well known programs such as rsync, cvs - both of which use a : character to delimit from the path component ( /path/to/repo). Hg clone you find that after successful ssh authentication you get the error message remote: abort: repository path/to/repo not found!, then you need to know the following: If your remote repository is cloned thusly I get an error while cloning a remote repository via ssh Please read the page "Dealing With Repository And Dirstate Corruption" for recommendations on what to do. If hg says No username found, using instead' when you make a commit, then you need to configure your username. If you want this for a script and need terser output, take a look at identify command flags and at scripting. The summary command will also tell you in brief what branch you're on, whether there are any newer changes than the one you're on, and what the state of your working directory is. Use the summary command ( TutorialClone shows an example call). For normal 32-bit OS, make sure the msi file does not have an 圆4 in it. You need to download and use the correct msi file for your OS. Contact your product vendor." This means you are trying to install a 64-bit version installer on a normal 32-bit operating system. ![]() "This installation package is not supported by this processor type. Windows: The installer aborts with an error message ![]()
0 Comments
Leave a Reply. |